Good Evening.
I have a 2010 1.6HDi VTR+Plus EGS and well the long and short of it I had to have the engine changed for a second hand one as the Cams, and lots of other stuff was knackered due to oil pipe getting blocked.
Well I had the Turbo, Clutch, Flywheel, and Actuator, Oil Pipe/Pump Timing belt, tensioners and MAF and other stuff replaced. Took over a week and was charged a pretty penny about 3k. (Wont get into that) But I noticed the the Glow plug light does not come on when the ignition is turned on. it starts alright but there again its summer. I have a copy of Diagbox but am a bit scared to use and where would i got to check that circuit.Shall I take it back to garage?
Any suggestions most gratefully received.
Thanks for your time, patience and experience.
I have a 2010 1.6HDi VTR+Plus EGS and well the long and short of it I had to have the engine changed for a second hand one as the Cams, and lots of other stuff was knackered due to oil pipe getting blocked.
Well I had the Turbo, Clutch, Flywheel, and Actuator, Oil Pipe/Pump Timing belt, tensioners and MAF and other stuff replaced. Took over a week and was charged a pretty penny about 3k. (Wont get into that) But I noticed the the Glow plug light does not come on when the ignition is turned on. it starts alright but there again its summer. I have a copy of Diagbox but am a bit scared to use and where would i got to check that circuit.Shall I take it back to garage?
Any suggestions most gratefully received.
Thanks for your time, patience and experience.